Part Number: TPS65100-Q1 Team,
can you please advise what is the recommendation on FB4 and Gate pins if the LDO is unused ? on the non Q1 version we can see that FB4 and gate should be connected to VIN.
thanks
Part Number: DLP2021-Q1 Other Parts Discussed in Thread: TPS65100 , , AM2632 Tool/software: Hello TI,
We are using LDO TPS6285018AQDRLRQ1 for 1.8V generation and TPS65100 chip for Voffset , Vbias and Vreset Voltages generation.
We have same Supply 3.3V available…
Part Number: TPS65100-Q1 Other Parts Discussed in Thread: TPS65100 Dear Sir/Madam.
Now I am using IC TPS65100-Q1 to drive power for the LCD 7-inch. I have checked the outputs, V01, V02, V03 are OK but VCOM is not OK.
Please help me check this issue and…
Part Number: TPS65100-Q1
Hi Aaron Goodson,
Excuse me, Could you help me about the topic:
https://e2e.ti.com/support/power-management/f/196/t/792070
Thanks,
CHJ
Part Number: TPS65100-Q1 Dear, our client change input capacitor and output capacitor, Capacitance and size, have any side effect? and add RC delay as below schematic:
217EA01-1A0_L TPS65100.pdf
If any suggestion, Please advise me.
Thanks,
Best regards, …
Part Number: TPS65100-Q1
Dear,
our client modify TPS65100-Q1 EN pin add RC delay and AVDD input 12.06v
Please help double confirm schematic as attached.
217EA01-1A0_TPS65100QPWPRQ1_EN pin & AVDD voltage modify confirm.pdf
and our client measurement…
Part Number: TPS65100-Q1 Other Parts Discussed in Thread: TPS65100
Tool/software: WEBENCH® Design Tools
Hi TI,
I want to use TPS65100-Q1 to driver TM080TDHG01 as the following link, I configure the parameter and draw the schematics below. Is it correct…
Part Number: TPS65100-Q1 Dear, i saw the TPS65100-Q1 Datasheet figure 15 as below chart 3 steps need 1sec, but we find our system 3 steps only 40ms was achived soft start. its normal ?
schematic
8802.217EA01-1A0 _TPS65100QPWPRQ1.pdf
if any suggestion…
Part Number: TPS65100-Q1 Other Parts Discussed in Thread: TPS65150-Q1
Dear, ourl client use design TPS65100-Q1, but we find two question, schematic as below.
217EA01-1A0 _TPS65100QPWPRQ1.pdf
1. VDD=3V, output VGH was drop issue. Could you explain this…
Part Number: TPS65100-Q1
Dear,
we fine tune RDC to EN pin ,but find the Iin (peak to peak) was too High, is could be normal behavior?
Vin=3V, R=21.98K+C=1uF as below chart: ; V p-p=1.19902A
Vin=3v R=50.95K+C=2.2uF ; V p-p=1.07706A
If any suggestion, Please…