Part Number: TPS7A4001-EP Tool/software: We noticed that the powerpad/paddle are recessed into the mold compound by about 10-30 microns on some of the parts we received.
On the same parts we observed some dye penetration that made it to the die attach…
Part Number: TPS7A4001-EP Other Parts Discussed in Thread: TPS7A4001 Tool/software: Hi,
I am using TPS7A4001 voltage regulator, we have designed in a 47nF capacitor for the the bypass which is connected between the feedback pin and the output as a low…
Part Number: TPS7A4001-EP Other Parts Discussed in Thread: TPS7A4001 Tool/software: Dear Sir:
I downloaded TPS7A40001.LIB LT Spice model from TI site.
Model has an extra "Bias" pin that actual IC does not have. What should I connect Bias pin…
Part Number: TPS7A4001-EP Other Parts Discussed in Thread: TPS7A4001 Tool/software: Customer wanted us to do worst case analysis (WCA) using component tolerance and temperature drift data running Monte Carlo pSpice simulation. After some experiments,…
Other Parts Discussed in Thread: TPS7A4001-EP , TPS7A4001 , TL783 , TPS7A43 Hello Regulator Folk,
I'm wondering if we have a LDO device that can accept 80~100VIN and 100~200mAload. VOUT is not specified yet but my customer under communication equipment market…
Part Number: TPS23861 Other Parts Discussed in Thread: TPS7A4001 , hi
we already talked about that problem here:
but we have some devices with older layout/schematic where we use exactly the same 3.3V LDO as you do. the TPS7A4001.
And with this layout the…
Hi Athun,
Unfortunately i could not find an LDO with this same package that is rated for -55C. Best i could find to match your specs (minus package) is the TPS7A4001-EP.
Hi Lars,
I can't believe I forgot about this when I sent my last response but Ryan Eslinger brought it to my attention that the TPS7A40 actually comes in an Enhanced Product (EP) version which extends it's operating temperature down to -55C.
TPS7A4001…
Other Parts Discussed in Thread: TPS7A4001-EP , LM117HV If the input-output voltage rating of 60V was exceeded by 200mV for up to 10usec for this device due to a transient on the input, would this be expected to cause damage? For reference, the nominal…