Part Number: TPS7A63-Q1
Hi team
Could you help check if TPS7A63-Q1 is supporting foldback current feature for short-circuit and overcurrent protection?
My customer needs a automotive LDO and VIN>36V, and they hopes the output current decrease to…
Part Number: TPS7A63-Q1 Hi Experts,
While using the TPS7A63-Q1, after the device power on,
nWD_EN Pin keeps LOW, WD Pin keeps LOW as well, how should WD_FLT Pin responds under this condition?
nWD_EN Pin is HIGH at first(turn to LOW 2s after…
Part Number: TPS7A63-Q1
Hi team
We would like to know does the TPS7A6350Q1 support output under voltage detection and over voltage detection? Since I only find the Vin-UVLO description in the datasheet, thank you.
Part Number: TPS7A63-Q1
Hi team
I search in TPS7A6350Q1 datasheet and not sure whether it supports 5V output under-voltage detection and over-voltage detection? Since I only found in datasheet it supports Vin-UVLO and we also see in page 19 it seems…
Hi ,
We rate our devices per the AEC Q100-002 standard. TPS7A63-Q1 is rated to the HBM ESD Classification Level H2 with a 4 kV HBM.
Please ensure that you follow the test procedure as specified by the Automotive Electronics Council:
Very Respectfully…
Part Number: TPS7A63-Q1 Other Parts Discussed in Thread: TPS7B70-Q1 , TLE4275-Q1 Dear TI:
I have noticed the datasheet of tps7a63-q1, the input voltage range from 4-40v change to 11-40v. I was a little confused . The battery voltage always form 9-16v…
Part Number: TPS7A63-Q1 Hello Team：
I have 2 questions about this IC
1. From the figure 22, the watchdog must receive service only duting open windows, MCU/DSP and this IC have their oscilliation frequencys respectively, so how to create a relationship…
Part Number: TPS7A63-Q1 Other Parts Discussed in Thread: TPS7B63-Q1 Hi team,
In this device, Figure7 shows output voltage vs input voltage.
If Vin increases especially above 40V, Iout seems goes down.
In this Vin case, how about the output voltage…
Part Number: TPS7A63-Q1 Hello Team,
The recommended value of Cin in the data sheet is stated as follows.
・Cin = 10～22uF (300mAmax)
Is it necessary to use the same Cin even when Iout=100mA(max)? Currently, 4.7uF x 2 is used. Is there a problem?…
Part Number: TPS7A63-Q1 Dear TI:
1. Cause 10 ms is the minimum pulse width required to correctly reset the mcu. So i used below schematic. But i was confused how to get the 5v i/o, it can be use divider resistor form Vbat. make sure the Ven<7v. or need…
