Part Number: TS5A4594 Hi there,
We would like to use the TS5A4594 but there will be instances when the voltage at IN, COM and NC will exceed V+ by a few volts as well as be lower than GND by a few volts. I plan to limit the current to these pins with resistors…
Part Number: TS5A4594 Other Parts Discussed in Thread: TS5A22362 , TMUX2889 , TMUX4827 Hi,
We are using TS5A4594DBVR in our design, but we need an alternate pin to pin compatible(except for gnd) part in such a away that it should support higher negative voltages…
Part Number: TS5A4594 Hi,
We are using TS5A4594DBVR in our design as per the attachjed image.
Here the purpose of TS5A4594DBVR is to connect or disconnect the 665 OHM resistir between pin 2 and 3 of Instrumentation amplifier to select Gain =1 or 10 for…
Part Number: TS5A4594
Hi,
From the datasheet of TS5A4594 you can assume that there is a clamping diode at Vno and Vcom that is connected to ground (<0V, -50mA).
Is not there a clamping diode connected also to V+ rail?
You can see an indication…
Part Number: TS12A4516 Other Parts Discussed in Thread: TS5A4594 Hi,
We are using TS12A4516 part in our design, providing 5V to V+ and gnd to V-.
Our doubt is Whether we can connect gnd to V- or not, because the datasheet says it is a dual supply IC.
Help…
Part Number: OPA1S2384 Other Parts Discussed in Thread: OPA1S2385 , , OPA2354 , TS5A4595 , TS5A4594 Dear team,
Could OPA1S2385 replace OPA1S2384 without hardware change? Seems they only have SC pin difference. Thanks a lot.
Part Number: TPS3823 Other Parts Discussed in Thread: TS5A4594 , Hello
My cstomer intend to use TPS3823A-30 for FY18 portable medical.
[Background of Question]
Customer’s concern is unexpected Reset.
Their CPU Transition timing may duplicate to internal…
Hello Jay,
Unfortunately we do not have a switch that will level shift with an active high enable, however, we do offer switches with similar voltage ratings and Ron with an active high enable such as the TS5A4594 (datasheet: www.ti.com/.../ts5a4594…
Other Parts Discussed in Thread: TS5A4594 , TS5A4595 I have a pullup resistor between the NO pin on a TS5A4594 and the IN pin on a TS5A4595.
The in pin on the TS5A4594 is low (disabled)
The voltage drop across the resistor indicates that there is about…
Other Parts Discussed in Thread: TS5A4594 , TS5A3167 Hello
I want to use this part in a sample and hold circuit with VCC=3.3V.
In the datasheet table for 3.3V supply Qc is typical 6pC, but Figure 5. Charge Injection (QC) vs VCOM shows from -0.6 to +0.8…