Part Number: TUSB1064 HI team,
TUSB1064 only has 2 lanes when switching U31 signals. Do we have a newer solution to switch 4 lanes of USB and 4 lanes of DP, which means 4 in 8out?
Thanks
Lillian
Part Number: TUSB1064 Dear E2E teams,
i use TUSB1064 for Typec to DP project.
TUSB1064 and DP receicer IC is on one board, so there is not DP Hot plug.
i pull up HPD of TUSB1064 with 4.7K all the time, is this OK?
thanks!
Part Number: TUSB1064 David-san
sorry to have kept for a long time.
I tried to check the swing level by differential probe again by using several laptop and desktop.
when I measure again it,
the swing level after TUSB1064 was increased.
I'm not sure…
Part Number: TUSB1146 Other Parts Discussed in Thread: TUSB1064 , , TUSB1064RNQEVM Hi Madam/Sir,
We were doing feasibility study for putting TUSB1146 at source, TUSB1064 at sink and connecting both thru a USB type C cable.
It expected to transmit up to…
Part Number: TUSB1064 Hi Team,
I need IBIS models for this part? I would like to simulate the TX and RX lines in a HyperLynx board simulation. could anyone please provide that?
Thanks
Narsimha
[Problem] decrease the swing of AUX after pass through TUSB1064_rev4.pptx
David san
sorry, moreover from above message,
let me update the information.
I measured swing voltage level for each section of AUX.
please refer to ppt slide and give us comment…
Part Number: TUSB1064 To compare TUSB1064 datahseet(page 32) and document(HSDC025A-002 Schematics.pdf), it shows different capacior value on USB TX/RX path
Attchement is our functon block, please advise the ac capacitor value(red color ellipse)
Part Number: TUSB1064 Other Parts Discussed in Thread: SN65DP159 , Hello,
we are design USB-C docking station based on TUSB1064. question: to drive HDMI port (from TUSB1064): can we use SN65DP159 or should we use MCDP2900 or STDP2650 active protocol converter…
Part Number: TUSB1064 Hi,
I would like to double check AUX to SBU signal only have mux, it don't have redriver function on these two pins, right?
Thanks!
Jeff
Part Number: TUSB1064 To whom may it concerns
we are using TUSB1064.
and we applied compliance test for DisplayPort.
However, the result is failed.
according to our checking,
the DC voltage for SBU1 from TUSB1064 become low comparing to TUSB1064 spec…