Part Number: UCC27321 Other Parts Discussed in Thread: UCC27289 , UCC27284 , UCC27212A-Q1 Hi team,
Does TI have same spec or better of pin driver solution? Competitor: EL7155CSZ-T7
Part Number: UCC27321 regarding this IC
i want to know its protection cutoff volatge.
i mean inside this IC there would a zener diode for protection purpose, i want to know its breakdown voltage.
Part Number: UCC27321 I am using a Ucc27321 gate drive to control IPB120P04P4L-03 mosfet @ 12volts driving resistive load.
Issue is when testing device for short circuit control I get a large voltage spike across mosfet Source of about ~30 volts with about…
Part Number: UCC27321 This driver is referred to as a low-side gate driver. I understand it cannot be used to drive a high-side N-channel MOSFET. However, is there any reason it cannot drive a high-side P-channel FET? My system is only 9V so I don't have…
Part Number: UCC27321 Hello,
I want to mount the two abovementioned IC's on a PCB but I've no clue about the orientation and the pin numeration.
Each IC is marked with a horizontal line that must indicate the orientation but, in the datasheet…
Other Parts Discussed in Thread: UCC27321 , UCC27322 , TINA-TI I need a TINA model for the UCC27321 driver ic, or a TINA circuit wherein this driver is used.
Although SPICE models are given for this ic, it does not give the .tsm file which is required to…
Part Number: UCC21750-Q1 Other Parts Discussed in Thread: UCC21750 , UCC27321 Dear expert,
What will be the best structure if my customer would like to add another buffer behind ucc21750 to strengthen the driving ability?
MOSFET or BJT? And what will be…
Other Parts Discussed in Thread: UCC27321 , UCC37321 Hi,
1)Compering the d/s of the UCC27321 and MICREL,MIC4421A,we found in the d/s that TI device has very low OUTPUT REsistance preformances,which look not realistic:
UCC37321 MIC4421A
OUT PUT RESISTANCE…
Part Number: UCC27524A Other Parts Discussed in Thread: UCC27321 Hi team,
we see in datasheet that when use the 2 output in parallel, it's recommend to add a resistor between OUTA and OUTB.
"Wherever possible, a safe practice would be to add an option…