Part Number: UC2842A Hi,
I have read datasheet of UC2842A and application circuit ( calculation ).
Questions :
1. Snubber Circuit ( RCD snubber selection ) Calculation not specified ? Please give the calculation details.
2. Is there any Simulation…
Part Number: UC2842 Hi,
I have read datasheet of UC2842A and application circuit ( calculation ).
Questions :
1. Snubber Circuit ( RCD snubber selection ) Calculation not specified ? Please give the calculation details.
2. Is there any Simulation…
Part Number: UC2842 Hi,
I am reading the datesheet of UC2842A. I understood that it is PWM controller. I understood the working of Flyback controller ( attached block diagram http://www.ti.com/lit/an/slva059b/slva059b.pdf or image attached in this thread…
Part Number: UC2842A Other Parts Discussed in Thread: TL431 Hi,
I understood the working of the Flyback circuit from the block diagram attached in this mail.
The driver circuit for the Power Mosfet is UC2842A. I understood that this is a PWM controller…
Part Number: TMS320F280049C Hi!
Please, I don't understand the definition of the GPIO41 - GPIO55.
In Table 4-1 page 27 (attached file tms320f280049c.pdf), there is a definition of this IO pins. But, this GPIO is not physical because they don't appear…
Hi Sarabech:
Our kernel uses the TDA4VE sdk linux 0806 version, but has been modified to some extent. See the attached file for defconfig.
6406.t1gc_defconfig.txt
Hi Sarabesh:
Our application layer changes the priority function as shown below
Our kernel uses the TDA4VE sdk linux 0806 version, but has been modified to some extent. See the attached file for defconfig.
t1gc_defconfig.txt
Keith,
1) don't use the old SMAs, use PSM712 from ProtekDevices.
2) The transient spec is actually nonsense. Applying a transient pulse through a current limiting resistor has absolutely nothing to do with the real world application.
I don't…
Hi steven,
thanks for your input.
1. What input voltage will be used? Is OVP not required (input FET is not blocking input adapter OVP)? What is the current limit for the input?
-> The input is connected to the adapter (5.0V/4A) through the eFUSE…
Hi Dennis,
you said that we could use any I/O pins for interfacing.i have a small dought if i take the LCD controller pins for interfacing the LCD how can i set the input and output directions because these are not the port pins.if i interfaced the…
