Hi Victor,
Unfortunately, I cannot give you a good answer for that. This is an older part and there is no body around that originally released this device.
We obviously need to update this datasheet to cause less confusion.
Thank you for bringing this…
Hello,
I'm looking for a dual channels DAC for a space radar. I need to use it at an update rate of 250MSPS. The ADC5652-EP is presented on the website with a maximum of 275MSPS, but the datasheet indicates it is "not production…
Hello Expert.
Thank you for your support every day.
I have any question about DAC5652.
1. In the table of data sheet P7,
It is described as tLAT (Clock latency) min.4 clk, max.4 clk.
I would like to know the MIN and MAX values.
2.…
Hello sir,
I wrote a vhdl code for sine wave generation.when I am connecting it to DAC5652 through HSMC card but It is not converting in analog when i am seeing result at oscilloscope.
may you suggest that what should…
we want to DAC5652 EVM Board designe source file.
- schematic source
( we found the DAC5672_REVB.pcb)
Hi,
I'm using DAC5652 to generator a waveform in every clock cycle, the CLKIQ&WRTIQ are 20MHz in phase.
My problem is when I fixed the SELECTIQ signal(pull-down or pull-high), I can't get the waveform from…
i want to generate sine wave with DAC5652,plz give me solution how to generate sine wave
Andreas,
No. You would have to build an adapter board or a harness to interface to the two different connectors. Both headers used have male pins. Some DAC board options are the DAC900, DAC902, DAC904, DAC908, DAC5652, DAC5662, DAC5672, and DAC5671 EVM…
Dear Friends and TI emploee,
We are working on DAC5652 and PIC32 controller, I am using DAC in dual bus mode. I am able to see clock and write signals on DSO but my output through RL is constant at 3.12v. Please…
