Part Number: ADC32RF45
I am using ADC32RF45 on a board of my own design. I would like to use the single ended SYNCB signal to pin 63.
When I write Jesd Digital page register 6036h to the value 40h to assert the CMOS SYNCB setting, then I can no longer…
Part Number: ADC32RF45 I have been through the documentation and forum posts on this issue. Forum thread 538392 contains a configuration file that suggests writing 0xAA to register 0x068 to freeze the correction. Forum thread 750250 mentions following…
Part Number: ADC32RF45 Other Parts Discussed in Thread: , LMK04828 Hi,
I am using ADC32RF45 at bypass mode at 12 bit 3GHz. My sysref frequency is continous with frequency something like 2.3...MHz. When I digitize a radar pulse modulated at 2250MHz, 2625MHz…
Part Number: ADC32RF45 I am operating my device in LMFS=82820 mode and JESD data arrives exactly as seen in Table 15 of the spec. Does properly functioning deterministic latency guarantee that samples from each of the four sub-ADCs (I don't know the correct…
Part Number: ADC32RF45 What register writes do I have to perform to enable the test pattern generator within the DDC (Figure 111 in datasheet)? I normally have the DDC disabled in my design. I added the following two writes to my initialization script…
Part Number: ADC32RF45 Hello,
I was just curious what a reliable setting would be for the RMS power detector threshold so that if it ever exceeded that level and I immediately turned off the input signal, I would not damage the ADC. The data sheet sa…
Part Number: ADC32RF45 Hello Guys,
Good day.
I just like to confirm. Description says 3.0-GSPS, dual-channel, analog-to-digital converter (ADC). , Is that Dual channel unit 3 Gbps on each of the 2 output channels, or 1.5 Gbps on each of the 2 output channels…
Part Number: ADC32RF45 Hello,
I am currently trying to verify if this ADC chip is right for my design. I am running it at a sampling rate of 3GSPS with an LMFS of 82820. I am trying to record a LFM signal that starts at 450MHz and ends at 1050MHz. Below…
Part Number: ADC32RF45 I am unable to read the Digital bank registers but i am able to the analog bank registers. I made an custom hardware with ADC32RF45IRMP and Xilinx Ultrascale+ SOC. And i configured the ADC bypass mode-8224 fs=2500Mhz, sysref=2.44140625…
Part Number: ADC32RF45 Hi Team,
Good day,
Customer want to confirm if there is a method were they can save the program in the device so that they do not need to reconfigure it in next power ON of ADC32RF45.
Thank you and looking forward for your kind response…