We are using the power supply as shown in the picture below.
Unfortunately, it is impossible to check whether the power is working properly with the equipment we have. However, We expect that the Power Supply will probably go in properly as it was purchased…
Part Number: AWR1843AOP Other Parts Discussed in Thread: AWR1843
I would like to know how to calculating 2Mhz Bit timing for can-fd(TCAN1469) like below.
I am using awr1843 aop chip.
dataBrp = 0x1U; dataPropSeg = 0x2U; dataPseg1 = 0x2U; dataPseg2 = 0x3U…
Part Number: AWR1843 Other Parts Discussed in Thread: SYSBIOS
Hi,
I tried to followed https://dev.ti.com/tirex/explore/content/radar_toolbox_2_00_00_06/source/ti/examples/Out_Of_Box_Demo/docs/Out_Of_Box_Demo_User_Guide.html#software, to get familier with…
Part Number: AWR1843 The Technical Reference Manual for the AWR1843 states that the L3 memory bank 6 and bank 7 are dedicated to BSS (section 11.3). It looks like the demo application define using all 8 banks. Does the BSS actually use these banks?
Part Number: AWR1843 I'm using AWR1843. I was trying a project giving in TI Research explorer, 'The Traffic Monitoring' Project which uses MATLAB. It is basically clustering the points of obstacles, and tracking them. But no where in the source code I…
Part Number: AWR1843 hi,
i am getting some warning message in mrr lab how to resolve the warning, bellow the warning message
<Linking> "../dss_mrr_linker.cmd", line 90: warning #10068-D: no matching section "../dss_mrr_linker.cmd", line 92…
Hi,
Apologies for the delay. While the pinmux changes look fine, the AWR1843BOOST is missing a 0 ohm resistor that needs to be added to R108 to test SYNC_OUT. I have not had time to do this and will keep you updated.
Could you confirm that your AWR1843BOOST…
Part Number: AWR1843 Hello TI support team:
How to get in "tiduen5a_maging Radar Using Cascaded mmWave Sensor " in secction 3.3 Antenna Calibration ?
Does it need to use specific tool(matlab...etc) ?
Thank you!