Part Number: CDCM61001 Other Parts Discussed in Thread: CDCM6208 , CDCI6214 , LMX2485E , LMX2571
Dear Sirs,
My customer is looking for low cost PLL or clock generator in place of
MB15F63UL ( IF block only )::::: please refer attached ppt.
:Vcc…
The competitor device does not specify jitter performance for these frequencies.
Can you please provide the following requirement specs for EACH output clock?
1) Phase noise / Jitter (include jitter integration bandwidth)
2) Frequency Accuracy (ppm…
Carlos,
If you want specific recommendations, the CDCM6208 used on the EVM is a recommended solution. We are using the CDCI6214 on newer EVMs which is also equally applicable.
Tom
Hi Vibhu-san,
My request is not to show the hidden registers information in the TICS-Pro software in the next updated version.
- User could see or access to the hidden registers from the RAW register page. - When saving the setting in .tcs file format…
Dear Lenny,
Thank you for reaching out on this topic.
TI offers a range of audio sample rate converters and some of them I am sure will have automatic input rate detection. You will find these in the audio section under sample rate converter. We…
Hi Shai,
CDC337 does not have its own evaluation board, we are not able to take any data.
LMK01801 is a newer device that meet your application requirement. It also accept LVCMOS input, see datasheet section 8.1.1.1.2 for details.
If you can give…
Hello Patrick, we have parts with 1.8V LVCMOS. You would have to use a voltage divider or pi pad to reduce the high level to 1.05V. Please take a look at CDCI6214, CDCLVC1310, LMK00105, LMK00101 and when 2.5V supply would be ok, too: CDCLVC1108. Only…
It's no problem to achieve < 50 ppm by selecting a proper crystal as a PLL reference that meets this frequency tolerance spec.
Other devices to consider is CDCI6214 or LMK03318, depending on performance vs. power needs. I suggest either of these if…
Takeshi-san,
88E1510 need a 25 MHz 1.8V LVCMOS clock. There are several clock solutions for your reference.
1. 25 MHz 1.8V LVCMOS XO (not TI's solution)
2. 25 MHz XTAL + CDCI6214 (a clock generator can provide up to 5 channels of 1.8V LVCMOS outputs…
Dean,
I appreciate the reply and might expect the 0.1" pitch headers to be a 235 mil "standard" post height but the 0.05" pitch is much more difficult to find standards for.
I'd love to at least see post length for the pins I hope to connect to an…
