Part Number: DDC118 Other Parts Discussed in Thread: DDC112 Hi,
I am not getting any document or application notes in Technical Document section of DDC118 on TI website.
Also, I found that DDC118 support SPI communication, but I found only DIN ~ MOSI…
Part Number: DDC118 Other Parts Discussed in Thread: DDC264
Hi Team.
My customer is using DDC118 for light sensing application. For improving EMC noise radiated from the 16MHz clock line, they have to change it to 4MHz, which is supported by DDC118.
…
Part Number: DDC118 Hi Team,
My customer is using DDC118 for light analysis and would like to seek for some advise on the following:
Should we choose continuous mode or non-continuous mode ? Our test will collect data only when user press start measurement…
Part Number: DDC232 Other Parts Discussed in Thread: DDC264
Hello,
I want to use the DDC232 without an FPGA directly connected to a Piccolo controller. In my application I want to connect a photodiode-array to the chip. The output-current FS-range lies…
Hi Daphne,
The DDC118 contains eight identical input channels that perform the function of current-to-voltage integration followed by a multiplexed A/D conversion. Each input has two integrators so that the current-to-voltage integration can be continuous…
Part Number: DDC118 I'd like to cascade two DDC118 chips but Figure 21 "Daisy-Chained DDC118s" in the datasheet only shows the serial data line connections. What does one do with the DValid and Conv signals (or any others that may be affected…
Part Number: DDC118 Other Parts Discussed in Thread: CC3200 Hello,
I am having some difficulties understanding the output format for the DOUT Pin on the ddc118.
Here is my Setup. I am using a TI Launchpad CC3200 as my master micro-controller. It is…
Part Number: DDC118 Hi,
In DDC118 datasheet, parametric table, it mentioned that the DC Bias Voltage is +/-0.05mV typical.
The definition of the DC Bias voltage is "voltage produced by the DDC118 at its input which is applied to the sensor", which is…
Part Number: DDC11XEVM-PDK Other Parts Discussed in Thread: DDC114 , DDC118 Hi,
I have the "ddc11xevm-pdk" evaluation module for the DDC114. Since I need 8 channels instead of 4, I wonder if I could replace the DDC114 on the board with a DDC118…