Part Number: DLP230NP Dear,
Hi,
Could you please let me know how to run init_parallel_mode.py to display an image? The image is in Raspberry Pi, so I just need the projector to recognize it and then display it. I have initialized communication between…
Part Number: DLP230NP We have a explanation for the rotation angle of DMD active array on the datasheet.
---ROTATION ANGLE OF DMD ACTIVE ARRAY IS A REFINEMENT OF THE LOCATION TOLERANCE AND HAS A MAXIMUM ALLOWED VALUE OF 0.6 DEGREES.
My customer want…
Part Number: DLP230NP Hi
We looked with a microscope and found that there were slight scratches and white spots on the exterior. Could you please help me confirm whether it affects the use? What is the cause of this?
Thank you
Part Number: DLP230NP When we recently used the DLP230NP, more than 2% of the DMDs randomly appeared bright pixels, which were not on the BBF lines. Is there a better direction for investigation?
In addition,this batch of DMD has been stored for 2 years, and of course it was stored according to s…
Part Number: DLP230NPDLP230NP .23 1080P DMD we use so far in factory, that DMD has blemish happened after this some DMD units was clearing, that blemish is still happened.
May I know this DMD spec? about blemish issue.
I use gray10 or blue60 pattern…
Part Number: DLP230NP Hi Experts,
DLP230NP .23 1080P DMD datasheet (Rev. C) (ti.com)
The above link is the datasheet. On the page 24,
"The conversion constant CL2W is based on the DMD micromirror array characteristics. It assumes a spectral efficiency…
Great. We will apply this knowledge and research a optical engine manufacture with working knowledge of creating the setup necessary. We need 3d files of the parts to add to the 3D model. I do not see any of those on the website. Could you have some sent…
Part Number: DLP230NP Hi Team,
Can you please check and advise with following request?
"
Within the scope of the study, an optical analysis setup must be set up.
We cannot open the attached file on the Texas Instrument site in Zemax 2013 (student…
Part Number: DLP230NP Dear TI-Support,
I ordered the above mentioned evalutation module. When I connected a suitable power source for the first time nothing happend. I already have one of these modules and therefore know that after initial start up the…