Hi Jared,
OPA314, TLV314, OPA316, TLV316, OPA376, and OPA377 are all auto qualified. Depending on the supply voltage the customer is using the OPA170, TLV170 and TLV171 might also work and are auto qualified.
Thank you,
Tim Claycomb
Nirav,
The LMP7721 has a non-standard pinout but your circuit should work the way your schematic shows it. What output voltage do you see? I suspect that you may have inadvertently swapped input or supply pins - please double check your connections…
JH,
You may NOT use chopper amplifiers like OPA333 or OPA188 with a bridge sensor input in the noise sensitive applications because the chopping front-end of this class of amplifiers intruduces a short duration (few nono-second) input bias, IB, current…
Other Parts Discussed in Thread: LMH6554 , OPA376 , TINA-TI Hello,
I`m currently design 5-channel 25 MHz sine clock distribution circuit.
LMH6554 was chosen because very low distorsion.
Each of five LMH6554 (single power 5V) sub-circuits convert…
Hi Michael,
I think that dVos/dT is likely uni-directional. For a given IC, the Vos will either go positive or negative in slope vs. temperature. dVos/dT will be positive in either cases.
Hi Shen Jun,
I think that the output resistor load is required…
Bob,
Below please see my asnwers:
Are the stated output current values of the REF sufficient for 3.3V (single-sided) supply to the OPA 350 and 1.65V for an offset bias under normal operating conditions for the OPA 350.
The minimum specified output…
Zec said: Can the OPA376 be prototyped on a solderless breadboard?
Yes if you add one of the parts from 'DIP-ADAPTER-EVM'.
Zec said: Once I get this project rolling, I intend to use it to design waveforms that can output to another MC(the MSP430FR5969…
SM,
You typically should calculate the noise refered to input, RTI, and then multiple it by the gain to refer to the output, RTO.
Doing so, for G=500, you will get: Vnoise RTI = [(8^2)+(80/500)^2]^0.5 = 8.0016nV/rt-Hz, which is in line with your…
Hi Jonathan,
I was forwarded some additional information from the local sales team about your application. We worked together and wanted to suggest the PGA2505 for your application. Here's some information about the PGA2505.
PGA2505 :
Allows…
Hello Srinivas,
Since you are comparing calculated and simulation results for the LMC6082 and LMC662 keep in mind that the simulated results are affected by the bias current, bias current offset, and voltage offset are established within the models…
