Search tips
Showing 10 results View by: Thread Post Sort by

  • TMUX7236: S/D line protection

    Part Number: TMUX7236 Other Parts Discussed in Thread: ESDS552 , TMUX7462F Tool/software: Hello all, I'm currently implementing the TMUX7236 in a design that should be able to switch between AI/RS485. I would like to protect this line from over/under…
    • Answered

  • TMUX7236: Normally ON without Vdd power

    Resolved
    Part Number: TMUX7236 Hello, Our customer looking for SPDT MUX with the function securing Normally ON even Vdd is not powered. A discrete solution can be achieved this by utilize depletion mode FET like FSA515. Is there any candidate MUX device…
    • Resolved
    • Answered

  • TMUX7236: technology discussion

    Resolved
    Part Number: TMUX7236 Dear, now customer evaluated TMUX7236 instead of ADG1436， Please confirm whether the single switch overcurrent of the switch chip is the value below，if yes， customer will use it , so please kindly confirm it , many thanks~
    • Resolved
    • Answered

  • TMUX6236: Datasheet Package Pinout not corresponding with data in pinout Table, (chapter: 4 Pin configuration and functions)

    Resolved
    Part Number: TMUX6236 Other Parts Discussed in Thread: TMUX7236 This post is made to warn designers wanting to use the TMUX6236 as there is an error in the datasheet. The datasheet was downloaded though the TI website via this link: https://www.ti.com…
    • Resolved
    • Answered

  • TCAN3413: Multiplexing CANH and CANL line with GPIO for logical switch for firmware mode selection

    Resolved
    Part Number: TCAN3413 Other Parts Discussed in Thread: TMUX7236 , TMUX6236 Tool/software: Hello Team, We are using TCAN3413 as a trans receiver in our design with RK3576 SoC for supporting CAN FD and classical CAN 2.0B protocol communication. We have…
    • Resolved

  • Automotive SPST/SPDT which support short to battery

    TI Thinks Resolved
    Other Parts Discussed in Thread: TPS25940-Q1 , TMUX7212-Q1 , TMUX7219-Q1 , TMUX7236 , TMUX4052-Q1 Hi Ti expert, Could you please help recommend a SPST or SPDT ,which can be used in vehicle interface, require to support short to battery (16v). Thanks…
    • Answered

  • TMUX7436F: Datasheet clarification

    Resolved
    Part Number: TMUX7436F Other Parts Discussed in Thread: TMUX7236 Hi Team, Can you please clarify the information found in the datasheet of TMUX7436F? In the image above, the single supply is 8V to 44V, and Dual supply +/-5V to +/-22V. On page…
    • Resolved
    • Answered

  • RS-232 XCVR - LVTTL interface

    Resolved
    Other Parts Discussed in Thread: TMUX7236 , TMUX6236 , MAX3386E , TRS3386E An IC that is similar to a common RS-232 transceiver except that the RS-232 interface is multiplexed with an LVTTL interface (TTL is acceptable too). We’d like the serial port…
    • Resolved
    • Answered

  • OPA277: If there have some the solution to absorbs the glitch from OP-amps by NPN and resistor?

    Resolved
    Part Number: OPA277 Other Parts Discussed in Thread: DAC8760 , TMUX1248 , TMUX7236 , TMUX6236 , OPA188 Hi everyone, How to clamp the output voltage of OPAmps to signal ground by the help of a switch whenever the supply voltage falls under a certain…
    • Resolved

  • [FAQ] Multiplexers and Switches Selection Guide | Mid Voltage Mux 25V =< VSIGNAL =< 99V

    The following table helps select th e right multiplexer and switch with Mid Voltage 25V =< VSIGNAL =< 99V in different configurations: Precision , Protection , Automotive , Extended Temperature Configuration 16:1…

Didn't find what you are looking for? Post a new question.