Part Number: TPS40210-Q1 Hi team,
Do we have any guide on sepic design with TPS40210-Q1? It is not illustrated in datasheet and EVM. Webench do not support Sepic circuit either.
Thanks,
Scarlett
Part Number: TPS40210-Q1 Other Parts Discussed in Thread: TPS40210 Hello,
according this sheet, the fit rates for AEC-Q and non AEC-Q are the same, can you confirm, that there is no difference in fit rates for this two versions? https://www.ti.com/lit/fs…
Part Number: TPS40210-Q1 Other Parts Discussed in Thread: TPS40210 , TPS40211 Hello,
is it possible to use the TPS40211 as an alternative for the TPS40210 by just adapting the feedback network, or do we have to expect any other regulation behavior because…
Part Number: TPS40210-Q1 Hi team,
I have a question that as the following picture,
We could only read through the figure to 'guess' the R,C value @100khz switching frequency, do we have calculation formula? Customer would like to know, how to calculate…
Part Number: TPS40210-Q1 Hi,
Can user set to ignore current limit on T PS40210QDGQRQ1 ? If yes, please advise us how to ignore current limit,
On his audio system using TPS40210-Q1, over current is occurred for a very short time, but he can detect it on…
Part Number: TPS40210-Q1 Hi,
When over 150mV (Typ) situation on ISNS pin of TPS40210QDGQRQ1 , this enters Overcurrent status. After that, Could you please let us know the flow to return normal output from overcurrent status?
Also, could you please let…
Part Number: TPS40210-Q1 Dear team,
We have a formula about how to select the output capacitor. In the formula, we usually give the minimum limit, but no maximum limit. If the output capacitor is too small, the output voltage ripple may be large which…
Part Number: TPS40210-Q1 Hi team,
My customer shorts Rsense resistor for some reason. It looks the device works normally.
But, I don't understand why the device can work correctly in this case. The inductor current sense voltage is used for the feedback…
Part Number: TPS40210-Q1 hi everyone,
I see that the RC pin connection suggestion is contradicting with the Absolute Maximum Voltage Rating of RC pin itself.
Could someone please clarify this?
Part Number: TPS40210-Q1 hi TI,
Requirements:
KL30T: 6V-16V (ISO7637-2 protected).
KL30T Quiescent Current Requirements: < 100uA.
I am having a Power Moding issue with Internal PD 1MOhm on DIS/EN^ pin as the PD means the TPS40210-Q1 will turn on by…