Part Number: TPS65910A3EVM-583 Other Parts Discussed in Thread: TPS65910 , TPS65910EVM After start-up and when load is dropped we observe the 3.3V VMMC to go up to 3.6V or even higher. Afterwards we see the voltage dropping normally slightly below 3.3V…
Part Number: TPS65910A3EVM-583 Other Parts Discussed in Thread: TPS65910 I am using am335x-GP-evm and trying to enable and use RTC available on PMIC. I am refering below thread and did changes to dts for tps & kernel config CONFIG_RTC_TPS65910=y. …
Part Number: TPS65910A3EVM-583 Other Parts Discussed in Thread: TPS65910 , USB2ANY , IPG-UI Customer is using TPS65910A3EVM-583 EVM for evaluation.
They observed no output at:- VDIG1, VDIG2 & VAUX33. J10 & J8 are installed on the EVM. Any additional settings…
Part Number: TPS65910A3EVM-583 Other Parts Discussed in Thread: TPS65910 Hello,
Regarding to ILMAX register on TPS65910AA1, my customer is asking some question.
They use 600MHz(@OPP100) on AM3554, currently ILMAX register of VDD_MPU is configured to…
Part Number: TPS65910A3EVM-583 Other Parts Discussed in Thread: TPS65910 In AM335X EVM Board without booting the processor we are getting PMIC Output VDIG1=1.8V, VMMC=2.45V . The same PMIC is used in my customized board where i am getting VDIG1=2.4V, VMMC…
Part Number: TPS65910A3EVM-583 Other Parts Discussed in Thread: TPS65910 Tool/software: Linux HI,
we are using pmic TPS65910A31A1RSLR in Am335X , supplier don't have the same IC's, so that they are suggesting alternate part TPS65910A3A1RSLR
can…
Part Number: TPS65910A3EVM-583 Other Parts Discussed in Thread: AM3352 , TPS65910 Hello,
Have a customer use TPS65910A3 PMIC for AM3352, have some questions about PMIC TPS65910A3.
1. The output voltage and sequential of TPS65910A3 follow below tables when…
Part Number: TPS65910A3EVM-583 HI ,
We are using TPS65910A3 as the PMIC for our AM335X based Board .
The PMIC is having a pin "nRESPWRON " . I am having a bit of a confusion with the pin . It is suggested to connect this pin to the "PWRONRSTn…
Part Number: TPS65910A3EVM-583 Hi ,
I am using TPS65910A3 to design my power system.
I have one key(or two keys ) use as a power on (power off) key.
Should I connect the button to which pin of TPS65910A3?
Thank you so much.
Angelo,
Indeed. I see FGH0H224ZF is of the -OH type in the datasheet, where -OH indicates a Maximum Operating Voltage of 5.5VDC.
As a result, it seems OK to set BBSEL = 11b if the input voltage, VCC7 (or VBAT) is <= 5.5V
For the most part, I would say…