Part Number: TPS65987D Hi Support Team,
two months ago there was a question regarding extended temperature range to -40°C. At that time, the end of the first quarter was envisaged for the change.
Is there already an update on this?
Thank you
Reg…
Hi Abdul ,
Apologies for the delay.
Please find my comments below -
1. PPHV2 not connected to any net. Please recheck. 2. I2C1_IRQ line is unused? 3. External resistor tolerance of 1% is required for ADCIN 4. Ground pin when HRESET functionality will not…
Part Number: TPS65987D Other Parts Discussed in Thread: TIDA-050014 Dear Member:
I designed a USB-PD source board using TPS65987D, and now I want to connect this board to TIDA-050014 to change the output voltage. However, the board can only output 5V…
Part Number: TPS65987D Other Parts Discussed in Thread: TUSB1046-DCI , HI Ti Team,
Please let me know, TPS65987D PD controller can configure the MUX (TUSB1046-DCI) as per below requirements automatically(CC pins detect the configuration and PD control…
Mr. Alex > Switched the USBCapable field of PDO1 to true. Test this configuration and see if anything changes. ⇒After checking, the desired behavior was achieved and the issue was resolved. thank you very much. To verify this, we confirmed the following…
Hi Johnsin,
Can you translate the latest message? I do not know Chinese.
Can you send a better resolution image, I downloaded the image but can not make out the net names.
Issue 1:
Do you have the SPI device hooked up properly, it looks like you have…
Part Number: TPS65987D Other Parts Discussed in Thread: TPS65988 Hi,
We use the TPS65987D for our USB PD controller, and we use the TPS6598X-CONFIG for the firmwave, we need the beow function for the USB PD:
1. Set GPIO0 to DP Mode Select Event
Asserted…
Part Number: TPS65987D Other Parts Discussed in Thread: TPS65981 Hi team,
Where is the bin file, generated by the TPS65981_2_7_8 Application Customization Tool?
I don't see any reminders.
Part Number: TPS65987D Hello, Let me confirm whether TPS65987D support eDP as alternate mode or not. When I check datasheet, it seems that you do not describe eDP as supported interface. However, when I checked community site such as below, it seems that…
Matthew,
We have https://www.ti.com/tool/TIDA-010047#design-products and other reference designs on https://www.ti.com/product/TPS65987D#design-development