Part Number: TPS92610-Q1 Can the DIAGEN pin be left open? I need to minimize current draw.. I plan on driving three LEDs with a max forward voltage of 8.4 V and the minimum supply voltage is ~11.0.
Part Number: TPS92610-Q1 Other Parts Discussed in Thread: TPS92613-Q1 , In a previous thread, my question was, "I understand that the SSL and SSH are tied together to Out. My question, "If I do not use the Single LED Short Detection feature, what would…
Part Number: TPS92610-Q1 Hi team,
A cusotmer asks some questions about TPS92610-Q1.
-. TPS92610-Q1 can be used for TFT LCD backlight?
-. For below configuration with TFT LCD(800 x 90), can TPS92610-Q1 support fine dimming control without brighteness issue and…
Part Number: TPS92610-Q1 Hello Team,
Please help us to recommended voltage level on FAULT pin of TPS92610, since we need to have high to low level for BCM, thanks.
1. The fault pin folating.
2. The fault pin connect cap to the ground.
Part Number: TPS92610-Q1 Hello TI,
Hybird topology use DCDC boost and LDO can decrease output capacitance. May I know 610 has high PSRR improve output capacitor useage?
Part Number: TPS92610-Q1 Hi, Team,
I am checking if the start up sequencing is problem or not.
-Customer is operating the system as,
1. Start PWM input (3.3V)
2. After a few msec, Supply 7V is ramping up
Then we would like to ask these questions, …
Part Number: TPS92610-Q1 Hi, Team,
Could I have an information how much delay time (Typ and Max) should be there in between PWM input and Output?
Thanks,
Best regards,
Koh
Part Number: TPS92610-Q1 Other Parts Discussed in Thread: TPS92630-Q1 Hello TI,
TPS92610 can use PWM pin implement Thermal foldback? if yes, can provide reference schematic? Thanks!!