Part Number: TRF7964A Hi All,
Can you confirm the minimum drive strength required for the crystal that can be connected to the TRF7964A. Specification is not included in the datasheet of the TRF7964A.
Best Regards
Byron
Part Number: TRF7964A Other Parts Discussed in Thread: DLP-7970ABP , MSP-EXP430G2ET Hi Andrea,
I able to successfully run the code from the TRF7970ABP_RFID_Reader_Demo using the Booster pack and the Launch Kit. The correct LED blinks when I use a 14443 Type…
Hello Becky,
the anti collision sequence is described in the ISO14443-3 spec. You can also leverage the application note " Implementation of ISO14443A Anti Collision Sequence in the TI TRF796 x". Although it is for TRF796x, it still can give you an…
Part Number: TRF7964A Other Parts Discussed in Thread: TRF7970A Hello,
Our customer is looking for any alternative part to TRF7964A with RED Certification?
Thank you in advance.
Cordially,
Art
Part Number: TRF7964A Other Parts Discussed in Thread: TRF7962A , , TRF7960A , TRF7970A hi team:
i want to double check that if i upgrade the RFID reader from TRF7962A to TRF7964A to support ISO14443A, is there any software setting need to pay attention to…
Part Number: TRF7964A Other Parts Discussed in Thread: MSP-EXP430G2ET , DLP-7970ABP Hi Andreas,
I received the LaunchPad (MSP-EXP4302ET) and am able to load an run the TRF7970ABP_RFID_Reader_Demo code, but it does read any tags.
The code seems to be stuck…
Part Number: TRF7964A Other Parts Discussed in Thread: MSP-EXP430G2ET
Hi ,
I am using the code from TRF7970ABP_RFID_Reader_Demo\NFC for ISO14443a card reading. When I reach the function ISO14443A_sendSelectCmd (shown below), g_sTrfStatus never equals RX_COMPLETE…
Part Number: TRF7964A Hello,
I am using TRF7964A and I have an conducted EMI problem.
The problem is mainly from the Frequency Component which is just outside the allowed band.
When we switch to the continuous waveform we don't have those components but…
Hi, There was no feedback since a while, so I will close this tread. You can still reply to this thread after it is closed, or you can create a new thread. Best Regards, Andreas.