Other Parts Discussed in Thread: TM4C129DNCZAD , TUSB1211 , TUSB1210 I'm looking for a high speed phy that will work with the TM4C129DNCZAD.
The TUSB1210 and TUSB1211 look like candidates, but according to their datasheets the IO voltage that they support…
Other Parts Discussed in Thread: AM3703 , TUSB1210 Dear Madam, Dear Sir,
We have integrated an AM3703 with a TUSB1210.
-During normal operation, we can read/write the registers in the transceiver.
-On our board we can control the reset line of the…
Hi,
We are using a standard USB pen drive or USB key board which are working fine on PC.
Our Working setup is as shown below:
The interface between DM3730 and USB3320 is shown below:
Now we replaced USB3320 with TUSB1210.
We also removed…
Part Number: WL1835MODCOM8B Other Parts Discussed in Thread: WL18XXCOM82SDMMC , , TUSB1210 I am trying to configure my Zedboaboard to work with WL1835MODCOM8B using the WL18XXCOM82SDMMC SD board connector. Zedboard is running Petalinux ver. 2019.1.
…
Other Parts Discussed in Thread: OMAP3503 , TUSB1210 , TUSB1211 I am using the TUSB1210 transceiver to connect to USB port 2 (HSUSB2) on the OMAP3503 processor. We find that occasionally after disconnecting and reconnecting a USB device from the transceiver…
Part Number: DP83867IR
Tool/software:
HI,Team.
We plan to use DP83867IR for product function design, using RGMII mode. I found the register mapping table in the manual. It is not clear how to use these registers. Can TI provide the initialization…
Other Parts Discussed in Thread: TUSB1210 My board used ehci host phy is tusb1210. kernel is linux 2.6.37 (psp 4.06.00.00.07)
The usb device is ZTE MG3732, is a high speed usb device,
the first connection is success.
[ 6.733367] usb 2-1: New USB…
Other Parts Discussed in Thread: TPS2540A , TUSB1210 Hi,
My customer evaluates the "TUSB1210 + TPS2540A" by the following circuit (circuit 1).
However, eye pattern does not open enough.
Is it correctable by a function of TPS2540A?
(The eye pattern…
The EVM design was not updated to use a TUSB1210. A limited number of EVMs were modified to use the TUSB1210 and these EVMs were used to verify operation with OMAP3530.
I have attached a Power Point file that shows the changes required to add a…
