Other Parts Discussed in Thread: SIMPLICITI , WMBUS Hi,
I watched the IAR webinar as advertised here http://e2e.ti.com/support/microcontrollers/msp43016-bit_ultra-low_power_mcus/f/165/p/48410/171265.aspx#171265 in a post
by Russell Miller
They…
Have you confirmed that the settings you use give the expected sensitivity using the normal FIFO mode?
Also see the settings used in www.ti.com/.../swra423.pdf ( processors.wiki.ti.com/.../Category:WMBUS ) as a starting point.
Other Parts Discussed in Thread: WMBUS , CC1120 Dear
I am middle of w m bus implementation on CC1120 at 169 MHz on my develop board FR5739.
To debugging use RF smart studio and TRXEB , TX board and RX board .
Able to transmit valid w m bus packet…
Other Parts Discussed in Thread: WMBUS , CC1120 , CC1125 , CC1200 Hi everybody, I'm using two CC1120 kits with two launch pads and I'm writing my own WMBus stack. Thing have been working fine until recently I got a new gas meter to test it with my kits…
Other Parts Discussed in Thread: CC1101 , WMBUS Hi all,
I'm facing a serious problem with a transceiver module realized with CC1101 in terms of compliance of EN 300220 V2.3.1 modulation bandwidth requirements.
I'll resume briefly my setup:
…
Part Number: CC1352P Other Parts Discussed in Thread: , UNIFLASH
Tool/software:
hi , i have CC1352P7 & P7-1 chipset with me i want to integrate it with Olimex Lime 2 A20 how i can do it ? i don't want to use launchpad development bord , want to direct…
Other Parts Discussed in Thread: CC1125 , WMBUS I am using CC1125 to receive wireless M-Bus packets from mode T meters and it works quite well even with large errors in frequency and data rate. The problem is that many packets are missed, and sometimes…
The post is now moved to the correct forum. Normally you can find the correct forum by typing the part number in the top left box on e2e.ti.com
In SmartRF Studio you have some suggested predefined settings if you select 'expert mode' tab. For 2.4 kbps…
Hello,
The smartRF studio gave me different values for the PKTCTRL0 and MDMCFG2. Anyway i changed to 0x32 and 0x33.
And i also added one byte to the TXFIFO.
So here is what i have now:
RF_ResetChip();
wmtest.chip_ver = RF_GetChipVer();
wmtest…
Other Parts Discussed in Thread: OPA392 , OPA182 , OPA186 How do Precision Amplifiers fit into my Grid Infrastructure design?
Overview Presentation:
Precision Amplifiers in Grid Infrastructure - Slide Deck
Featuring designs for Rogowski Coils…
