USB2ANY: USB2ANY

Satheesh M B

Part Number: USB2ANY
Other Parts Discussed in Thread: TPS546B24AEVM-1PH, TPS65400EVM-678

We have USB2ANY hardware and it is not detected by Fusion GUI.

Is FUSION GUI supports USB2ANY hardware? or we need to have the USB-to-GPIO device for this!

Thanks

over 5 years ago

0 Amiel Hussain over 5 years ago

TI__Expert 4070 points

Hello, which chip are you trying to connect with?

0 Satheesh M B over 5 years ago in reply to Amiel Hussain

Prodigy 10 points

The Evaluation board we use is TPS546B24AEVM-1PH;

0 Amiel Hussain over 5 years ago in reply to Satheesh M B

TI__Expert 4070 points

Hello Satheesh, your question is being routed to the responsible group.

0 Lishuang Zhao over 5 years ago in reply to Satheesh M B

TI__Expert 7500 points

Hi Satheesh,

FUSION GUI supports USB2ANY hardware. Can you check your hardware setup first especially the USB2ANY setup?

https://www.ti.com/lit/ug/snau228/snau228.pdf

If it still can't connect, please let us know.

Thanks,

Lishuang

0 Satheesh M B over 5 years ago in reply to Lishuang Zhao

Prodigy 10 points

Hi Lishuang,

I have referred the USB2ANY user manual for connecting the USB2ANY hardware with EVAL boards.

Case1:

Connected the USB cable between PC and USB2ANY hardware.
Connect USB2ANY and TPS546B24AEVM-1PH using 10 pin connector;
- One end of 10 pin connector connected to J4 of USB2ANY and other end to connector J2 of TPS546B24AEVM-1PH
Supply the power to TPS546B24AEVM-1PH : VIN and GND to T2 and T3
Launch the FUSION_DIGITAL_POWER_DESIGNER GUI and below was the response

Case2:

Connected the USB cable between PC and USB2ANY hardware.
Connect USB2ANY and TPS65400EVM-678 using 30 pin connector;
Supply the power to TPS65400EVM-678
Launch the PI-Commander-PMU EVM GUI (TPS65400EVM-678 supported GUI) and GUI was able to detect USB2ANY
Able to communicate with TPS65400EVM-678 EVAL board.

So the question over here is do we need to do anything different for communicating with TPS546B24AEVM-1PH?