TINA-TI: Circuit is too big

Leon Ni

Prodigy 50 points

Part Number: TINA-TI

Dear,

When I use Tina try to do LDO transient simulation, I add one self-made Macro (this is one cable model).

Transient simulation can not be done, "Circuit is too big" error shows.

How could I fix this?

Brs,

Leon

over 3 years ago

0 Ben C over 3 years ago

TI__Guru 56345 points

Hi Leon,

Is this a LDO question or for a voltage reference?

Ben

0 kai klaas69 over 3 years ago

Guru 140200 points

Hi Leon,

please post the TINA-TI file.

Kai

0 Leon Ni over 3 years ago in reply to kai klaas69

Prodigy 50 points

50Ohm_4M_Cable_GSPICE.lib

This .lib file is OK in Cadence Pspice simulation, however it stops TINA work.

0 LeonardEllis over 3 years ago

TI__Guru 71526 points

Hello Leon,

Thank you for your inquiry about TINA. Since TINA is a DesignSoft/TINA program, questions are handled by using the DesignSoft support page: http://www.tina.com/technical-support/ .

The DesignSoft/TINA team is very helpful and this is the most direct way for TINA support. Please advise by Reply when the issue has been resolved.

Regards,

~Leonard

Amplifiers

Amplifiers forum

TINA-TI: Circuit is too big