OPA330: OPA330AIYFFR

David Henry

Part Number: OPA330

This part is configured as a buffer using OPA330AIYFFR.

When 0.5V is applied to the input I measure 2.2V, the correct value should be close to 0.5V. Please help to verify if there is an issue with the part.

over 2 years ago

0 Raymond Zhang1 over 2 years ago

TI__Guru 55851 points

Hi David,

Could you share with me what is the load connected to the output of the OPA330? If there is capacitive load connected at the output of the op amp, please send me an image of the drive.

Best,

Raymond

0 kai klaas69 over 2 years ago

Guru 140200 points

Hi David,

why not showing a schematic?

Kai

0 David Henry over 2 years ago in reply to kai klaas69

Prodigy 10 points

Hello Kai,

Found the issue there was a damage part on the PCB. Fractured part.... you can close out

0 Raymond Zhang1 over 2 years ago in reply to David Henry

TI__Guru 55851 points

Hi David,

Thanks for the confirmation!

It will be quicker to provide us with a schematic and load conditions. As you did, you may contact our FAE and they are able to reach us directly via email or phone call etc..

Thanks,

Raymond

Amplifiers

Amplifiers forum

OPA330: OPA330AIYFFR