INA180: INA180-There is a problem with the test

xiaoqian wang

Part Number: INA180

After installing the chip, using high pressure, direct smoke, using low pressure, AD value is large, there is no problem with replacing it with our previous materials.

over 3 years ago

0 Castrense Nigrelli over 3 years ago

TI__Expert 4720 points

Hello,

I suggest you do a check for shorts and continuity after you solder down the new part. Also you should clean the board of flux before powering the board up.

What part is smoking? Is a circuit schematic available?

Regards,

Castrense

Amplifiers

Amplifiers forum

INA180: INA180-There is a problem with the test