USB2ANY: Dimension of the box or enclosure

Danilo A.

Part Number: USB2ANY

Hi Team,

Our customer would like to know the dimension (Length x Width x Thickness) of the box or enclosure of the USB2ANY development tool. May I request this information?

Regards,

Danilo

over 3 years ago

0 Raymond Zhang1 over 3 years ago

TI__Guru* 77521 points

Hi Danilo,

Below is the link from a previous inquiry. We do not use the product in our team. I will forward it the thread to a different team and see if they are able to provide you with the dimension of enclosure.

The dimensions of the board are 2.17 inch by 3.12 inch, and the thickness of the PCB is 0.062".

https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/1047290/usb2any-dimension?tisearch=e2e-sitesearch&keymatch=usb2any%2520dimension#

Best,

Raymond

0 Derek Payne over 3 years ago in reply to Raymond Zhang1

TI__Mastermind 33730 points

Hi Danilo,

Exterior dimensions of the USB2ANY enclosure are 3.25" x 2.30" x 0.80". I don't have tolerance information for those parameters, but they may be available from the manufacturer. The base model is Serpac C10,GY enclosure: https://www.serpac.com/c-series/c10.aspx. We make some modifications to expose the USB port, connection LED, bootstrap loader button, and keyed 30-pin header port, and stamp the TI logo and internal part number on it, but it would take me time to find (someone who still has) the modification specs

Regards,

Derek Payne

0 Danilo A. over 3 years ago in reply to Derek Payne

TI__Mastermind 28750 points

Hi Raymond and Derek,

Thank you very much for this information.

Regards,

Danilo

0 Danilo A. over 3 years ago in reply to Danilo A.

TI__Mastermind 28750 points

Hi Team,

Our customer would like to ask for the following dimensions.

We would need with more details about the enclosure: dimensions of connector gaps in microUSB connector and 30-pin connector.

Also we would need a PN of a 30-pin round cable connector, equivalent to the 30-pin flat cable connector that USB2ANY has.

Regards,

Danilo

0 Derek Payne over 3 years ago in reply to Danilo A.

TI__Mastermind 33730 points

Danilo,

Apologies for delay, I was out sick.

I haven't been able to track down anyone with the modified specs for the connector holes. It should be possible to work backward from the USB connector dimensions, though you did say USB micro which implies the connector would be changed. Modifying the USB2ANY to use a round cable connector instead of a 30-pin header, or for that matter a USB micro-B connector instead of a USB mini-B connector, is outside of the scope of assistance I can provide.

There are a few posts on E2E that can point you to the documentation for the USB2ANY schematic and BOM (example: https://e2e.ti.com/support/amplifiers-group/amplifiers/f/amplifiers-forum/1076361/usb2any-unable-to-update-the-firmware-on-my-usb2any).

Regards,

Derek Payne

Amplifiers

Amplifiers forum

USB2ANY: Dimension of the box or enclosure