• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 46 subscribers
  • Views 425 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

INA200: Please tell me about INA200's behavior.

INA200: Latch Mode

Hans
Genius 12865 points

Part Number: INA200

Hello Team,

according page 7 data sheet CMPOUT should be high when RESET is high at power up:

But according to fig. 28 CMPOUT = low from the start:

Also the simulation shows that CMPOUT = low at the start, even when RESET = high.

Can you confirm that the simulation shows the correct behavior, please?

Thanks and Best Regards,

Hans

  • 0
    TI__Mastermind 35620 points

    Hi Hans,

    The datasheet quote is referring to comparator's behavior at power on, when supply voltage ramps from 0V to say 5V. In this situation, if /RESET is high, the comparator output will latch high even if comparator input is below threshold.

    The datasheet waveform is referring to behavior post power up, when supply voltage is stable. Your simulation is probably under similar working condition as well, not power-on transient. 

    Regards, Guang

  • 0 in reply to Guang Zhou
    TI__Genius 12865 points

    Hello Guang, thanks for the comment about the power up. I simulated this and luckily the simulation shows exactly what you described!

    Thanks and Best Regards,

    Hans