• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 48 subscribers
  • Views 412 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ADS8900EVM-PDK User Manual/Board Labeling mismatch

Jeremy Grata
Prodigy 20 points

The User Guide for the ADS8900EVM-PDK references jumpers and jumper locations not on the ADS8900EVM board.  There are also jumpers on the ADS8900EVM board not referenced in the user guide. Where can we find jumper configurations for the ADS8900 for differential and single ended inputs?

Our board has 
J1,J2 both only 2 pin jumpers
J3,J7 the analog inputs
J4,J6 3 pin jumpers with one pin indicated with a 1
J8, 3 pin jump with non of the pins annotated
There is no JP5b or any JP marked jumpers (ie only marked J)
The analog input J3 does not have any 2.5V or 2.6V selectors.
The manual shows the following:
  • 0
    TI__Guru 50290 points

    Hello Jeremy,

    We updated the ADS8900BEVM about 2 years ago, and updated the user's guide as well.  I think you have the previous version of the EVM board.  The previous version of the User's Guide is attached which should match your board.

    sbau269a.pdf

    If this user's guide does not match your board, please include a photo of your board.  Thanks.

    Regards,
    Keith Nicholas
    Precision ADC Applications