OPA548: POWER PAD

Hiroyuki Uesugi

Part Number: OPA548

Hello,

Is the POWER PAD connected to V-(4pin) inside the device?

Should the POWER PAD be connected to the V-(4pin) on the PCB?

Thank you for your help.

regards,

+1 Clemens Ladisch over 1 year ago

Guru 276440 points

Section 10.1.2 says:

The tab of both packages is electrically connected to the negative supply, V–.

You can connect the pad to V– or let it float. What to do is likely to depend on how you want to heat sink it.

0 Hiroyuki Uesugi over 1 year ago in reply to Clemens Ladisch

Thanks for your good response, I appreciate it.

0 Hiroyuki Uesugi over 1 year ago in reply to Clemens Ladisch

Thanks for your good response, I appreciate it.

0 Chris Featherstone over 1 year ago

Hiroyuki,

Let us know if you have any further questions. Thanks for the answer Clemens!

Best Regards,

Chris Featherstone

Amplifiers forum