Other Parts Discussed in Thread: ADS127L11, , OPA2206, PGA280
Hello TI,
I'm working on a signal chain that inputs into an ADS127L11 for measurement. The chain was designed and simulated specifically for low noise.
Unfortunately, I'm seeing much higher real-world noise than was simulated.
Would it be possible for someone at TI to take a look at the schematic and provide feedback? I cannot publish it here, as the entire design is covered by an NDA.
I have the entire schematic replicated in Tina, which hopefully makes this request a bit easier.
Could I send it directly to someone to look over?
The chain includes PGA280, OPA2206 and OPA2320.
Thank you very much,
Ben
