Other Parts Discussed in Thread: TINA-TI
Tool/software:
Good day,
I am simulating an amplifier based on OPA2992 using TINA-TI. I get good results when I use the inbuilt battery in TINA-TI. However, I get distorted output waveforms when I power the same OPA2992 circuit with a DC-DC converter.
below are the waveforms
When I use the inbuilt battery:
and when I use the DC-DC converter outputting the same voltage as the battery?
How best can I get the desired waveform while using a DC-DC converter? Attached is the simulation file.
