LMH6572 & LMH6570 Spice model

Jeannette ZHAO

Other Parts Discussed in Thread: LMH6572, TINA-TI, LMH6570, LMH6714, LMH6514

Hello, my design group is planning to use LMH6572 and 6570 parts into our new product. However, I could not find any Spice model on line which will affect our simulation results. I am wondering if anyone can send me the spice model of these two parts? Thanks,

over 10 years ago

0 Andrew_Mason over 10 years ago

TI__Expert 6395 points

Hello Beiping,

This is being looked into.

Regards,

Andrew

0 Jeannette ZHAO over 10 years ago in reply to Andrew_Mason

Prodigy 30 points

I could not see any info was post by you, could you post t again? Thanks,

0 Hooman Hashemi over 10 years ago in reply to Jeannette ZHAO

TI__Mastermind 22825 points

Hello Beiping,

Unfortunately the LMH6570 and also the LMH6572 do not have a TINA-TI or Spice model available!

This may sound a little odd, but you could model the LMH6570 with the TINA-TI model for the LMH6714, since these devices are closely related. The LMH6714 model is available here, or directly from within TINA-TI:

http://www.ti.com/lit/zip/snom116

To simulate the Mux, use the SEL signal to toggle a "Single Pole Change Over Relay" on the amp input (available within TINA-TI) with proper switching times set. I've done that below for the LMH6570:

Here is the TINA-TI file corresponding to the schematic above, if you like to experiment with it:

2425.LMH6714 to Mimic the LMH6570 Hooman 1_13_14.TSC

Regards,

Hooman

0 Jeannette ZHAO over 10 years ago in reply to Hooman Hashemi

Prodigy 30 points

I do not see how I could use LMH6714 to replace LMH6572 as LMH6714 is an op amp, and LMH6572 is a mux

0 Loren Siebert 1 over 10 years ago in reply to Jeannette ZHAO

TI__Genius 13935 points

Hello Beiping,

You would be using the LMH6514 model only to simulate the LMH6572 signal path performance. Hooman even showed how to incorporate the mux function into the TINA model. Hooman was not suggesting that you use an LMH6714 to replace the MUX in your system design, he was just stating that the LMH6714 has similar frequency response, distortion and voltage swing capabilities to the LMH6572.

Regards,

Loren

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Amplifiers

Amplifiers forum

LMH6572 & LMH6570 Spice model