Inquiry about Muti-Cal system EVM

Daekeon Woo

Prodigy 120 points

Other Parts Discussed in Thread: SYSBIOS, PGA309

Hello, I'm a Daekeon as a pressure sensor developer from Autonics in Korea.

Now, I use your system to calibrate zero or span to my products.

But, It happened that the zero calibration is error so I want to solve this problem for launching that.

The following are my Inquiry.

1. I want see this program source. Is it possible that you send source?

2. I wonder what feedback are implemented to calibrate proper value.

Please Answer my questions. Thank you for your helping.

over 12 years ago

0 judahvang over 12 years ago

TI__Mastermind 32475 points

Daekeon,

Sorry, your posts is very vague. I'm not sure you are even in the right forum. What device are you on?

#1. What program source are you asking for? SYSBIOS?

Just trying to understand what you are looking for.

Judah

0 Daekeon Woo over 12 years ago in reply to judahvang

Prodigy 120 points

Judah

Hello, Thank you for sending reply.

The software that i told you is "PGA309 EVM software" .

I want to see this program code.

0 David Friedland over 12 years ago in reply to Daekeon Woo

TI__Mastermind 18320 points

You posted your question in an embedded processing forum, but it appears that your question is analog related. I have moved this post over to what I am guessing may be a more appropriate forum in hopes that you will get an answer there.

0 Ian Williams over 12 years ago in reply to David Friedland

TI__Mastermind 27715 points

Hello Daekeon,

Here is the source code for the PGA309EVM: http://www.ti.com/lit/zip/sboc320

And here is the source code for the Multi-Cal System: http://www.ti.com/lit/zip/sboc391

Both of these programs are coded in LabVIEW, so the LabVIEW developer version is required in order to view and edit the code.

Best regards,

Ian Williams
Linear Applications Engineer
Precision Analog - Op Amps

Amplifiers

Amplifiers forum

Inquiry about Muti-Cal system EVM