LM7171: Why did the marking come off when welding?

user5184406

Intellectual 395 points

Part Number: LM7171

Hi,

I bought the part of LM7171BIMX/NOPB, and when I use them found the marking come off when welding.

The original marking on the part is "BIM" while the marking changed to "AIM" after weld.

Can you give us an explanation why does this happen?

over 8 years ago

0 Jacob Freet over 8 years ago

TI__Expert 8720 points

Hi,

The markings are just lightly engraved into the device package material and can be effected by contact with abrasive materials or soldering irons. It is also common that they can become harder to read with the naked eye after cleaning because it can remove any material in the letters that makes them easier to see.

Regards,

0 user5184406 over 8 years ago in reply to Jacob Freet

Intellectual 395 points

Hi,

The original marking on the part is "BIM" while the marking changed to "AIM" after weld.
Can you give us an explanation why does this happen?

0 Jacob Freet over 7 years ago in reply to user5184406

TI__Expert 8720 points

Hi,

I believe some of the device molding compound melted or was touched by a hot iron. The markings are etched into the device, so they can be altered if accidentally touched by a soldering iron.

Regards,

Amplifiers

Amplifiers forum

LM7171: Why did the marking come off when welding?