Hi TI Support Team,
I've a strange behaviour concerning the Enable/Disable function.
I've a couple of OPA454, one is a basic non-inverting, the other is inverting ...
They should drive alternatevely a load and the E/D function is very useful for that, but ... What i observe during the simulation with TINA is:
For non-inverting configuration, the E/D works very well, while for inverting configuration the output is not really "disabled" and there is a residual of the signal ....
I join the TINA schematic, please run the transient analysis and look at VouP (the good) and VoutN (the bad) signals ...
Thanks in advance for your help.
Andrea
