Hello guys,
One of my customers is considering using TLC081C for their new products.
They have a few questions about the device.
Could you please give me your reply?
Q1. Can NULL pins of TLC081A be left open when offset calibration is not needed?
Q2. I can see the condition, "Rnull=0ohm" in the graph, "phase margin vs load capacitance"
as Figure 19 on page 12 in the device datasheet (Version No.SLOS254F).
What does "Rnull=0ohm" mean?
Is it connecting between NULL pins? Or is it leaving each NULL open?
Your reply would be much appreciated.
Best regards,
Kazuya.
