LMV225: Effect on rubber magnets

Sadanori Kato

Part Number: LMV225
Other Parts Discussed in Thread: LM3262,

Hi,

Could you please tell me whether there are any concerns when the rubber magnet comes close to LMV225URX/NOPB during the mounting process.
The similar post is as below.

LM3262 Effect on rubber magnets
https://e2e.ti.com/support/power-management/f/power-management-forum/985044/lm3262-effect-on-rubber-magnets

Best regards,
Kato

over 3 years ago

+1 dBrock over 3 years ago

TI__Genius 12780 points

Hi Kato,

In particular to the LMV225, I do not expect that there will be any issue with a magnet coming close to the component during mounting/assembly.

In line with the comments from the post you shared, care must be taken to ensure that any induced voltage does not exceed the ABS max values in the data sheet.

Best Regards,

Dan

0 Sadanori Kato over 3 years ago in reply to dBrock

Guru 36530 points

Hi Dan-san,

Thank you for your prompt reply.

I understand.

Best regards,
Kato

Amplifiers

Amplifiers forum

LMV225: Effect on rubber magnets