Frequent Questions

  • [FAQ] AM2634-Q1: How to enable LWIP host name in AM263

    Part Number: AM2634-Q1 LWIP enabled devices can get IP address from DHCP server based on host name. To enable this feature on LWIP stack, certain configuration needs to be done. - Let us pick the enet_cpsw_tcpserver example to enable this feature…

  • [FAQ] AM263P4: How to block ethernet packets with a particular unicast address?

    Part Number: AM263P4 Ethernet packets can be blocked or forwarded based on their packet addresses. Unicast address is a specific type of address that is intended for one to one communication. ALE in CPSW susbystem can be configured to drop packets…

  • [FAQ] AM2634-Q1: How can I persist a data structure from my code in flash storage on an AM263 microcontroller?

    Part Number: AM2634-Q1 Other Parts Discussed in Thread: SYSCONFIG , UNIFLASH This FAQ highlights how you make a datastructure to be stored in flash in AM263 microcontroller. Typically we can do this in AM263Px and AM261x microcontroller where XIP…

  • [FAQ] AM263P4-Q1: How to flash/program custom external flashes

    Part Number: AM263P4-Q1 Other Parts Discussed in Thread: UNIFLASH This FAQ explains how to setup the flash utility to flash into external flashes which are not supported out of the box. The method mentioned in this FAQ would be the same for AM261 and…

  • [FAQ] TDA4VH-Q1: How to enable heartbeat monitoring and autonomous recovery of inter domain cores in J784S4?

    Part Number: TDA4VH-Q1 How to enable the constant monitoing of the linux and remotecores of main domain from mcu domain core (mcu1_0)? If core is crashed and detetion is done by monitoring, how to enable autonomous recovery?

  • [FAQ] DP/HDMI/SDI/DPHY Products FAQ Master List

    Part Number: TDP2004 This Master FAQ lists serves as a point of reference to find all FAQs made by TI's signal conditioning Team. DPHY: 1. [FAQ] SN75DPHY440SS: Is it okay to swap the polarity and lane order? - Interface forum - Interface - TI E2E…

  • [FAQ] AM625: Booting AM62x with Minimal DDR Guide

    Part Number: AM625 This FAQ answers questions about minimum DDR requirement on AM62x, boot-time memory usage, and what changes are needed to boot successfully with reduced DDR. This FAQ is still in progress.

  • [FAQ] MSPM0-SDK: Software and Evaluation Board Design Resources for Application note of Single Phase AC Shunt Power Monitor with Low Cost MSPM0

    Part Number: MSPM0-SDK This thread is used to update the software or hardware update for application note of Single Phase AC Power Monitor with MSPM0 Hardware_Software.zip

  • [FAQ] C2000Ware - Errata

    Part Number: C2000WARE Other Parts Discussed in Thread: C2000WARE , SYSCONFIG This post is meant to specify erratas /document any refinements or clarifications discovered after the C2000Ware release. Sysconfig migration/Switch feature in Sysconfig…

  • [FAQ] TDA4VL-Q1: ADC AIN7 measures a higher voltage than expected

    Part Number: TDA4VL-Q1 Other Parts Discussed in Thread: TDA4VL , TDA4VH When using the MCU_ADC0 or MCU_ADC1 on TDA4VL or TDA4VH, the voltage measured on ADC0_AIN7 or ADC1_AIN7 has a higher voltage than expected (i.e., for an expected voltage of 0.8V…

View FAQ threads