Other Parts Discussed in Thread: PUREPATH-CMBEVM, TAS5805
I'm new to PurePath Console 2. I have selected the target, configured the desired Audio Processing, and then when I click on the Direct I2C Read/Write tab, most of the top half of the display (particularly the Register Dump pane) is grayed out.
Is it possible to dump the I2C register values without the PUREPATH-CMBEVM board connected?
I had hoped to dump the register values and then just write some custom code on a microcontroller to push the I2C register values to the DSP/amplifier IC.
I don't currently own a PUREPATH-CMBEVM board. Is the board absolutely essential to use PurePath Console, or is there some way of dumping the register values?
Apologies if this is a very basic question. I have been following the PurePath Console Online documentation and the Hybrid Processor user guide for the IC, but I may have missed this detail.
Screenshots are below.