• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 31 subscribers
  • Views 846 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TAS3308 I2S input to SPDIF and PWM output

Mathias Buholzer
Prodigy 40 points
Other Parts Discussed in Thread: TAS3308

I use PurePath Studio GDE V.1.8.2 to programm the TAS3308 EVM - Low Cost.

Firstly I like to loop the I2S input signal to the PWM outputs and the SPDIF Output. Just to test the device is running correctly. Unfortonally I don't see someting on the outputs. Did I miss someting? The ProcessFlow is like these:

  • 0
    TI__Expert 3215 points

    Mathias,

    Have you tried using the example that came with the EVM, analog in/analog out and the .cfg file example provided?  Let's route out little by little to see what could be wrong.

    And also, we have a latest PPS release 1.88 b5, it would be a good pratice to update to the latest.

    Regards,

    Susan