TAS5713 - How to get the biquad values from the TAS57x GUI?

Thomas Arens

Other Parts Discussed in Thread: TAS5713

Hi,

I am planning to use the TAS5713. I would prefer not to buy the evaluation board.
The TAS57x GUI is great for configuring the filters, but without the evaluation board I am not able to get the biquad values from the software.

Is there a way to get the biquad values from the GUI? (I tried version 3.1, by the way.)

Thank you for your time.

Best regards,

Thomas Arens

over 13 years ago

0 Don Dapkus over 13 years ago

TI__Guru**** 189399 points

Hi, Thomas,

Unfortunately, the GUI requires to connect to the EVM in order to display the values (as you've found).

-d2

0 Thomas Arens over 13 years ago in reply to Don Dapkus

Prodigy 60 points

Thank you for your quick answer.
Is there a possibility that this feature might find its way into a later version of the GUI?

0 Don Dapkus over 13 years ago in reply to Thomas Arens

TI__Guru**** 189399 points

Thomas,

Due to the way this GUI was architected, it would be a very difficult feature to add now.

-d2

Audio

Audio forum

TAS5713 - How to get the biquad values from the TAS57x GUI?