• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 30 subscribers
  • Views 187 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DIT4192: Schematic Check

Reed
Expert 1320 points
Part Number: DIT4192

Hi team,

Please help check DIT4192IPWR schematic. Thanks!

  • 0
    TI__Mastermind 22110 points

    Hi Reed,

    I will take a look at it tomorrow.

    Regards,

    Arash

  • 0 in reply to Arash Loloee
    TI__Mastermind 22110 points

    Hello,

    Few recommendation on the connection.

    For I2S signals it is better to add a 22 to 100Ohm series resistor, I see it only for MCLK.

    If the device is intended to be in slave mode the M/S pin needs to be configured accordingly.

    For RSTZ, probably having a pullup resistor is a good idea.

    Digital input pins such as FMT0/FMT1   need to be tied to high or low based on the need. For digital pins please follow datasheet for specific needs.

    Regards,

    Arash