Can't find TAS5719 device in TAS570X GED?!

Mehdi Chafik

Other Parts Discussed in Thread: TAS5709, TAS5719, TAS5719EVM, TAS5717EVM

Hello,

I have downloaded TAS570X GED (2.1 build 14). When i start a new design, on the right side, i can select the device. My problem is that only 5707, 5708 or 5709 appear? If i load a default pfw file (TAS5709_10_default.pfw for example), i can change the device to 5709,5710 or 5711! So i'm new to this and completly lost. Do i have the right software? Should i use another device number (similar to 5719)?

BTW, I can connect in I2c w/o problems. I used the I2C memory tool and got "6c" for adress "0x00".

Haven't gone further than that. Would like to know if this is normal or not?

Any help appreciated.

over 11 years ago

0 Ravi Singh over 11 years ago

TI__Mastermind 22965 points

Hi Mehdi,

The GUI for TAS5719 is available for download on the TAS5719 device webpage. (http://www.ti.com/product/tas5719)

You might also want to refer to the application-note titled "Setting TAS5717EVM/TAS5719EVM Environment variable" that is also available on the same TAS5719 device webpage.

-Ravi

0 Don Dapkus over 11 years ago in reply to Ravi Singh

TI__Guru**** 189399 points

Hi, Mehdi,

Did you get this sorted out?

-d2

0 Mehdi Chafik over 11 years ago in reply to Don Dapkus

Prodigy 60 points

Hi Don, and thanks Ravi for the link,

Didn't have much time to test it. I downloaded the software and started it. I was able to select my device, only problem is that i can't find the component toolbar or add a wire between existing components in the default design (i don't have a toolbar at the top like shown in the help, the file menu is also different with only an exit command).

Like i said i didn't have much time, only tested it for a few minutes without the EVM connected to the pc. That might be the problem?

Anyway, i'm going to spend some time on it this week.

Mehdi

0 Don Dapkus over 11 years ago in reply to Mehdi Chafik

TI__Guru**** 189399 points

Mehdi,

The TAS57xx family are ROM-coded, you can't change the process flow, you can only change the coefficients in the blocks like BiQuads, DRC, Volume, etc.

-d2

Audio

Audio forum

Can't find TAS5719 device in TAS570X GED?!