• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 31 subscribers
  • Views 396 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TAS5630 PBTL IN_C, IN_D sitting

Janusz Dlubak
Prodigy 30 points

Hallo

Datasheet page3, "MODE SELECTION PINS" tabele.

What is the difference between AD mode and BD Mode?

I suppose that

in BD mode OUT_B is parallel to OUT_D and OUT_A is parallel to OUT_C

In AD mode (OUT_A II OUT_D)    and (OUT_B II OUT_C)

Was I right?

  • 0
    TI__Guru**** 189399 points

    Hi, Janusz,

    There is a huge amount of information in e2e that is at your finger tips merely by searching. For example, we have a Design Note that describes this exact question! You can find it here.

    Does anyone in the community have any comments on preference of AD vs BD?

    -d2