Make TAS3308EVM-LC self boot

h.moden

Hello,

I need to use the TAS3308EVM-LC in demo purpose and use it without a computer. In other words, I need it to self-boot when I connect the USB-power. How is this done?

I have read a suggestion in this thread :

http://e2e.ti.com/support/amplifiers/audio_amplifiers/f/6/t/64.aspx but it didn't make me wiser.

Please advice!

Regards,

Helge

over 14 years ago

0 Neil A Quarmby over 14 years ago

Intellectual 455 points

Helge, I built some versions of the init component to do the same thing as the I2C commands sent by PPS at reset. You should place these init modules on your process flow. There is no conflict with the I2C commands, so both can be used.

Have a look at http://e2e.ti.com/support/amplifiers/audio_amplifiers/f/6/t/46821.aspx

Regards

Neil Quarmby

www.milton-electronics.com