Hi,
Could tell me the values of LC filters which you would recommend for 2ohm load impedance with BTL mode ?
Best regard,
Kato
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
Could tell me the values of LC filters which you would recommend for 2ohm load impedance with BTL mode ?
Best regard,
Kato
Hi Gregg-san,
I have additional questions.
For Cout I found that there is mentioned in TAS5414C-Q1 data sheet as below.
I believe that 2.2uF is too large, so could you please double-check it ?
In addition, please tell me the range(Min and Max) for the output inductor value which you would recommend ?
Best regards,
Kato
Hi Gregg-san,
Thank you for your advice.
I have an additional question.
Could you please tell me the minimum inductor value which you would recommend if getting the audio bandwidth more than 40kHz ?
Our customer is considering to use TAS5414C-Q1 with 2 x BTL @ 40W ~ 50W.
Best regards,
Kato
Hi Gregg-san,
Thank you for your support.
Could you please tell me whether a 5.6uH inductor and a 1.5uF capacitor can be applied to TAS5414C-Q1 or not just in case ?
Best regards,
Kato