Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

  • State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 28 subscribers
  • Views 316 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LME49860: Power-on and off Sequence

Sadanori Kato
Guru 36530 points
Part Number: LME49860

Hi,

Could you please tell me the recommended power-on and off sequence with the dual power supply(+15/-15V) ?

Best regards,
Kato

  • 0
    TI__Guru** 102045 points
    Hi Kato-san,

    As many other OpAmps, the power sequence would be the following:
    -During Power Up sequence, turn on the supply first, then apply a signal at the input.
    -During Power Down, turn off the input signal first, then turn off the power supply.
    Ideally the supply voltages should rise simultaneously.

    If supplies does not rise simultaneously, and there could be a signal present at the input during power up/down, current-limiting resistors can be added at input and output to try to reduce the current flows during this startup time.

    Best regards,
    -Ivan Salazar
    Applications Engineer - Low Power Audio & Actuators
  • 0 in reply to Ivan Salazar
    Guru 36530 points

    Hi Ivan-san,

    Thank you for the information.

    I understood.

    Best regards,
    Kato