• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 29 subscribers
  • Views 252 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

TAS2557: Asking for the TAS2557 speaker characterization process

TAS2555: Speaker Characterization Process

Adonis Mansour
Prodigy 70 points
Part Number: TAS2555

Hello,

I followed this thread to attempt to get to the characterization page: https://e2e.ti.com/support/audio/f/6/t/710748?tisearch=e2e-sitesearch&keymatch=speaker%20characterization

After deleting the current configuration, it reloads the default config. It will not allow me to enter the characterization setup:

Please advise, and I apologize for the low quality image.

Thanks,

-Adonis

  • 0
    TI__Guru* 96045 points
    Hi Adonis,

    This happens because learning board 2 is not connected. The GUI enters to speaker characterization panel when this additional board is connected.

    Best regards,
    -Ivan Salazar
    Applications Engineer - Low power Audio & Actuators