Other Parts Discussed in Thread: PUREPATHCONSOLE, TAS5548
Hello experts,
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello experts,
Hi Ryo,
Sorry but we don't have related materials. Would you like to take a look at the TAS5548EVM-GUI? It can also be used to configure the EQ function. Hopefully it helps.
Thanks!
Regards,
Hao
Hello Hao,
Hi Ryo,
I mean you may run the TAS5548EVM-GUI offline, set your EQ curve in the visual window, get the register values by "save settings", and then open the saved files.
GUI->Loudness1->Launch Loudness Filter-> Choose "Equalizer(Bandwidth)" in "Filter Type"->Input your parameters and check the curve in the window below->"Save settings"-> Read the settings in "Paramter" lines.
I'm not sure if it can help here. Please take a try. Thanks!
Regards,
Hao
Hello Hao,
Hello Hao,
Hello Hao,
Hello Hao,
Hi Ryo,
No. I mean you can leverage this GUI to get the EQ parameter design. As you have seen in the <parameter> lines, these results can be manually wrote into TAS5508C registers.
Thanks!
Regards,
Hao
Hello Hao,
Hi Ryo,
That's a good point. If you refer to Table 10 on TAS5548 datasheet, there is an example exactly the same with TAS5508C. The design parameters are also exactly the same. So I think the result you get from TAS5548 can be applied to TAS5508C directly.
Thanks!
Regards,
Hao
Hello Hao,